Royal Enfield Interceptor 650 - Service manual > Chassis

Chassis

See also:

 Royal Enfield Interceptor 650 - Service manual > Magneto Cover Sub Assembly

Stator coil with CPS in Magneto cover Position stator coil (a) inside magneto cover such that. The Crank position sensor is seated at its mounting location. Magneto wires and grommet are aligned to the slot on the top of the cover. The stator mounting holes are aligned to the mounting holes in magneto cover. Locate 3 Nos. Hex socket head bolts (M6) (b) in the stator coil mounting holes and tighten evenly to specified torque. Locate guide plate (b) over the CPS (a), ensure the mounting holes of the guide plate, CPS are aligned to the mounting holes in magneto cover. Locate 2 Nos. Hex socket head screws (M5) (c) on the guide plate and tighten evenly to specified torque. Locate dowel pins (a) and (b) into crankcase. Install gasket (a), if necessary smear engine oil and ensure it is properly seated on dowels. Do not use any sealant or adhesive. Align the magneto cover such that the stator coils are located into the magneto rotor and ensure proper seating of the cover against the gasket.

 Royal Enfield Interceptor 650 - Service manual > Air Filter Box Assembly

Dismantling Air Filter Element

Motorcycles: